null Skip to main content

Sharpened Early Disston D-23 - 26", 11 ppi, Crosscut

Disston

€204.12
Condition:
Refurbished
Adding to cart… The item has been added

This is a Disston D-23 from Pete Taran's personal collection, an early example judging by the shape of the handle. I sharpened it to 11 ppi crosscut, a fine tooth count for finish work, and it's ready to cut. A previous owner repaired a horn on the handle; the details are under Honest condition.

At a glance

Maker Disston
Model D-23 (straight-back)
Approximate era 1917–1940
Length 26 inches
Plate 6-1/2" at the heel, 1-1/2" at the toe
Points per inch 11, crosscut
Etch Good
Sharpened by Aaron Yes — ready to cut

What I did to it

  1. Disassembled and inspected. Every part came off the saw and was checked before cleaning.
  2. Cleaned to preserve character. Handle and hardware were cleaned in a way that keeps the saw's age visible — no over-polishing.
  3. Plate cleaned. Cleaned properly while preserving the etch.
  4. Jointed and shaped. Toothline jointed and refiled for crosscut work.
  5. Sharpened to 15° rake, 20° fleam. Standard general-use crosscut geometry.
  6. Set. Minimum set applied — just enough to let the plate glide in the kerf without binding.

Honest condition

The etch is good. A previous owner repaired a horn on the handle, and the photos show the repair. I'm happy to answer questions about it.

About the D-23

Disston introduced the D-20 series, a mid-priced line, in 1911. The D-23 is its straight-back, narrow-width model, and it became one of Disston's best sellers. It stayed in the line until the Disston family sold the company in 1955. Disston considered the finish a grade above the D-8, and in 1928 the 26-inch D-23 sold for $3.85 against $3.45 for the D-8.

The handle is how you spot an early one. Before 1928 the D-23 had a carved handle with a small notch at the top and a smaller hand hole, and the slot for the blade shows through the top. In 1928 Disston moved to a covertop handle with a larger hand hole and a relief for the second hand. This saw has the earlier shape. Disston's 1918 and 1928 catalogs offered the 26-inch D-23 in crosscut from 7 to 11 ppi, so 11 was the finest tooth count you could order.

About Disston

Henry Disston founded the company in Philadelphia in 1840, and by the late 1800s Disston was the largest saw maker in the world. Disston saws were the standard against which every other maker was measured for nearly a century.

Who this saw is for

A woodworker who wants a high-tooth-count crosscut saw for finish work: cutting parts to length and working close to the line, with a smoother cut that leaves less to plane off. At 11 ppi it cuts more slowly than a coarser saw. For breaking down rough stock or ripping, pick a saw with fewer points per inch.

Questions about this saw? Email me at aaron@benchandchisel.com — I answer them all.
— Aaron, Bench & Chisel